Mon–Fri 9am–5pm · (902) 755-6532

S&S Cycle · Low-end torque

S&S Cycle 551 Cam: Horsepower & Torque Gains

Touring cam that's strongest from idle to 4,000 rpm.

This is a torque-focused grind. It pulls hard from low rpm, keeps the bike easy to ride in traffic, and suits heavy touring bikes and two-up riding.

Engine
Twin Cam 103
Est. output
91 hp
109 ft-lb
Gain
+6 hp
+10 ft-lb
Rank
#20 hp
#8 torque of 24

Estimated Gains by Engine

Rear-wheel estimates for a Stage 1 engine (high-flow air cleaner, 2-into-1 exhaust and custom tune, or a performance carb) before and after the S&S Cycle 551, which makes it a Stage 2 build. Twin Cam numbers are calibrated against Fuel Moto's back-to-back Twin Cam 103 cam shootout.

EngineStockStage 1Stage 2 with 551Try it
Twin Cam 11088 hp / 100 ft-lb99 hp / 110 ft-lb105 hp / 121 ft-lbOpen in calculator →
Twin Cam 10376 hp / 90 ft-lb85 hp / 99 ft-lb91 hp / 109 ft-lbOpen in calculator →
Twin Cam 9669 hp / 82 ft-lb78 hp / 90 ft-lb82 hp / 100 ft-lbOpen in calculator →
Twin Cam 8863 hp / 73 ft-lb71 hp / 81 ft-lb75 hp / 89 ft-lbOpen in calculator →

Supporting Mods for the S&S Cycle 551

  • Required: Hydraulic cam chain tensioners. The stock shoe-style tensioners wear out, and a cam install is the time to replace them.
  • Recommended: Adjustable pushrods. They let us install the cam without pulling the rocker boxes, saving labour.

S&S Cycle 551 FAQ

How much horsepower does the S&S Cycle 551 add in a Stage 2 build?

On a Stage 1 Twin Cam 103 (high-flow intake, 2-into-1 exhaust and a custom tune), we estimate the S&S Cycle 551 adds about 6 hp and 10 ft-lb at the rear wheel, for a Stage 2 build of roughly 91 hp / 109 ft-lb.

What engines does the S&S Cycle 551 fit?

The S&S Cycle 551 is listed for the Twin Cam 110, Twin Cam 103, Twin Cam 96 and Twin Cam 88. Fitment can vary by model year, so we confirm compatibility with your exact bike before ordering.

Does the S&S Cycle 551 need a tune?

Yes. A cam changes how much air the engine moves, so a fuel-injected Harley needs a tuner and tune (ideally a custom dyno tune) to run properly and make the gain.

Is the S&S Cycle 551 a good cam for me?

This is a torque-focused grind. It pulls hard from low rpm, keeps the bike easy to ride in traffic, and suits heavy touring bikes and two-up riding.

Estimates for a healthy engine. Real results depend on condition, the rest of the build, the tune and the dyno.

Install the S&S Cycle 551

Arch Customs installs and dyno tunes Harley cams at our shop in Stellarton, Nova Scotia, with tensioners, pushrods and every supporting part done right.

Build it in the calculatorRequest a quote
(902) 755-6532
Book Service