Mon–Fri 9am–5pm · (902) 755-6532

S&S Cycle · Mid-range

S&S Cycle 475C Cam: Horsepower & Torque Gains

S&S's bolt-in 120+ hp cam for 114 and 117 ci engines.

This grind is built for the middle of the rev range, where most riders spend their time. Expect a stronger pull for passing and highway roll-ons than a pure torque cam.

Engine
M8 114
Est. output
107 hp
132 ft-lb
Gain
+11 hp
+10 ft-lb
Rank
#9 hp
#3 torque of 15

Estimated Gains by Engine

Rear-wheel estimates for a Stage 1 engine (high-flow air cleaner, 2-into-1 exhaust and custom tune, or a performance carb) before and after the S&S Cycle 475C, which makes it a Stage 2 build.

EngineStockStage 1Stage 2 with 475CTry it
Milwaukee-Eight 10778 hp / 101 ft-lb88 hp / 111 ft-lb98 hp / 120 ft-lbOpen in calculator →
Milwaukee-Eight 11485 hp / 111 ft-lb96 hp / 122 ft-lb107 hp / 132 ft-lbOpen in calculator →
Milwaukee-Eight 11793 hp / 116 ft-lb105 hp / 128 ft-lb117 hp / 138 ft-lbOpen in calculator →
Milwaukee-Eight 117 High Output103 hp / 118 ft-lb112 hp / 126 ft-lb125 hp / 136 ft-lbOpen in calculator →
CVO Milwaukee-Eight 11793 hp / 116 ft-lb105 hp / 128 ft-lb117 hp / 138 ft-lbOpen in calculator →

Supporting Mods for the S&S Cycle 475C

  • Recommended: Adjustable pushrods. They let us install the cam without pulling the rocker boxes, saving labour.
  • Recommended: A heavy-duty clutch spring. At around 132 ft-lb the stock clutch may start to slip.

S&S Cycle 475C FAQ

How much horsepower does the S&S Cycle 475C add in a Stage 2 build?

On a Stage 1 Milwaukee-Eight 114 (high-flow intake, 2-into-1 exhaust and a custom tune), we estimate the S&S Cycle 475C adds about 11 hp and 10 ft-lb at the rear wheel, for a Stage 2 build of roughly 107 hp / 132 ft-lb.

What engines does the S&S Cycle 475C fit?

The S&S Cycle 475C is listed for the Milwaukee-Eight 107, Milwaukee-Eight 114, Milwaukee-Eight 117, Milwaukee-Eight 117 High Output and CVO Milwaukee-Eight 117. Fitment can vary by model year, so we confirm compatibility with your exact bike before ordering.

Does the S&S Cycle 475C need a tune?

Yes. A cam changes how much air the engine moves, so a fuel-injected Harley needs a tuner and tune (ideally a custom dyno tune) to run properly and make the gain.

Is the S&S Cycle 475C a good cam for me?

This grind is built for the middle of the rev range, where most riders spend their time. Expect a stronger pull for passing and highway roll-ons than a pure torque cam.

Estimates for a healthy engine. Real results depend on condition, the rest of the build, the tune and the dyno.

Install the S&S Cycle 475C

Arch Customs installs and dyno tunes Harley cams at our shop in Stellarton, Nova Scotia, with tensioners, pushrods and every supporting part done right.

Build it in the calculatorRequest a quote
(902) 755-6532
Book Service