Mon–Fri 9am–5pm · (902) 755-6532

Cycle-Rama · Mid-range

Cycle-Rama 575 Cam: Horsepower & Torque Gains

Wide power band for stock and modified engines.

This grind is built for the middle of the rev range, where most riders spend their time. Expect a stronger pull for passing and highway roll-ons than a pure torque cam.

Engine
Twin Cam 103
Est. output
94 hp
107 ft-lb
Gain
+9 hp
+8 ft-lb
Rank
#18 hp
#16 torque of 24

Estimated Gains by Engine

Rear-wheel estimates for a Stage 1 engine (high-flow air cleaner, 2-into-1 exhaust and custom tune, or a performance carb) before and after the Cycle-Rama 575, which makes it a Stage 2 build. Twin Cam numbers are calibrated against Fuel Moto's back-to-back Twin Cam 103 cam shootout.

EngineStockStage 1Stage 2 with 575Try it
Twin Cam 11088 hp / 100 ft-lb99 hp / 110 ft-lb109 hp / 119 ft-lbOpen in calculator →
Twin Cam 10376 hp / 90 ft-lb85 hp / 99 ft-lb94 hp / 107 ft-lbOpen in calculator →
Twin Cam 9669 hp / 82 ft-lb78 hp / 90 ft-lb85 hp / 98 ft-lbOpen in calculator →
Twin Cam 8863 hp / 73 ft-lb71 hp / 81 ft-lb78 hp / 87 ft-lbOpen in calculator →

Supporting Mods for the Cycle-Rama 575

  • Required: Hydraulic cam chain tensioners. The stock shoe-style tensioners wear out, and a cam install is the time to replace them.
  • Recommended: Adjustable pushrods. They let us install the cam without pulling the rocker boxes, saving labour.

Cycle-Rama 575 FAQ

How much horsepower does the Cycle-Rama 575 add in a Stage 2 build?

On a Stage 1 Twin Cam 103 (high-flow intake, 2-into-1 exhaust and a custom tune), we estimate the Cycle-Rama 575 adds about 9 hp and 8 ft-lb at the rear wheel, for a Stage 2 build of roughly 94 hp / 107 ft-lb.

What engines does the Cycle-Rama 575 fit?

The Cycle-Rama 575 is listed for the Twin Cam 110, Twin Cam 103, Twin Cam 96 and Twin Cam 88. Fitment can vary by model year, so we confirm compatibility with your exact bike before ordering.

Does the Cycle-Rama 575 need a tune?

Yes. A cam changes how much air the engine moves, so a fuel-injected Harley needs a tuner and tune (ideally a custom dyno tune) to run properly and make the gain.

Is the Cycle-Rama 575 a good cam for me?

This grind is built for the middle of the rev range, where most riders spend their time. Expect a stronger pull for passing and highway roll-ons than a pure torque cam.

Estimates for a healthy engine. Real results depend on condition, the rest of the build, the tune and the dyno.

Install the Cycle-Rama 575

Arch Customs installs and dyno tunes Harley cams at our shop in Stellarton, Nova Scotia, with tensioners, pushrods and every supporting part done right.

Build it in the calculatorRequest a quote
(902) 755-6532
Book Service