Body (B) · IM / BCM
Harley Code B1004
Fuel level sending unit low
What B1004 means
The fuel level sender signal is out of range, so the fuel gauge may read empty, full or not at all.
The fault type in B1004
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A failed fuel level sender
- →A damaged connector at the fuel pump
- →Wiring damage under the tank
What to check first
- Inspect the fuel pump and sender connector
- Test the sender resistance
Is it safe to ride?
Rideable, but track your mileage since the fuel gauge can't be trusted.
Related fuel level sender codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.