Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · TSM / BCM

Harley Code B1006

Accessory line overvoltage

Ride with caution

What B1006 means

The accessory power line saw too much voltage or load.

Common causes

  • →Aftermarket accessories drawing too much current
  • →A shorted accessory wire

What to check first

  1. Disconnect accessories one at a time and re-test
  2. Inspect accessory wiring

Is it safe to ride?

Accessories may shut off. Find the faulty item before a long ride.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service