Body (B) · IM / BCM
Harley Code B1210
Fuel level sender shorted low/open
What B1210 means
The fuel level sender signal is out of range, so the fuel gauge may read empty, full or not at all.
The fault type in B1210
Short to ground
The circuit is touching ground somewhere it shouldn't, so the module sees little or no voltage. On a motorcycle this is usually a wire with worn-through insulation rubbing on the frame, or water in a connector.
How it's tested: Unplug the component and the module, then check the signal wire for continuity to ground. Any reading means the short is in the harness, not the part. Look closely where the harness bends at the steering head and passes along the frame.
Open circuit
The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.
How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.
Common causes
- →A failed fuel level sender
- →A damaged connector at the fuel pump
- →Wiring damage under the tank
What to check first
- Inspect the fuel pump and sender connector
- Test the sender resistance
Is it safe to ride?
Rideable, but track your mileage since the fuel gauge can't be trusted.
Related fuel level sender codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.