Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · Various

Harley Code B0563

Battery voltage high (security module)

Ride with caution

What B0563 means

A module saw supply voltage that was too low or too high. Low voltage usually points to the battery, connections or charging system. High voltage usually points to a failed voltage regulator.

The fault type in B0563

Signal or voltage high

The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.

Common causes

  • →A weak or failing battery
  • →Loose or corroded battery terminals and grounds
  • →A failed stator or voltage regulator
  • →Jump-starting or charger problems

What to check first

  1. Load-test the battery
  2. Clean and tighten battery terminals and main grounds
  3. Test charging output at idle and 2,000+ rpm

Is it safe to ride?

Low or high voltage can strand you or damage electronics. Test the battery and charging system before a long ride.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service