S&S Cycle · Top-end power
S&S Cycle 640 Cam: Horsepower & Torque Gains
Big-inch race-style grind. Not for stock engines.
This is a top-end grind. It gives up some bottom-end grunt to make more power at higher rpm, and it rewards riders who like to rev the engine out.
Estimated Gains by Engine
Rear-wheel estimates for a Stage 1 engine (high-flow air cleaner, 2-into-1 exhaust and custom tune, or a performance carb) before and after the S&S Cycle 640, which makes it a Stage 2 build.
| Engine | Stock | Stage 1 | Stage 2 with 640 | Try it |
|---|---|---|---|---|
| Evolution 80 (Big Twin) | 57 hp / 68 ft-lb | 65 hp / 74 ft-lb | 75 hp / 76 ft-lb | Open in calculator → |
Supporting Mods for the S&S Cycle 640
- Consider: This grind makes its best power with more displacement or compression, so it's usually paired with a big bore kit.
- Recommended: Adjustable pushrods. They let us install the cam without pulling the rocker boxes, saving labour.
- Consider: The S&S Cycle 640 makes its best power with more displacement or compression. A milder grind may suit a 80 ci engine better.
- Consider: A programmable ignition so timing can be matched to the new cam.
S&S Cycle 640 vs Similar Cams
Other top-end power grinds on the Evolution 80 (Big Twin), same supporting parts.
Full Harley cam comparison chart →S&S Cycle 640 FAQ
How much horsepower does the S&S Cycle 640 add in a Stage 2 build?
On a Stage 1 Evolution 80 (Big Twin) (high-flow intake, 2-into-1 exhaust and a custom tune), we estimate the S&S Cycle 640 adds about 10 hp and 2 ft-lb at the rear wheel, for a Stage 2 build of roughly 75 hp / 76 ft-lb.
What engines does the S&S Cycle 640 fit?
The S&S Cycle 640 is listed for the Evolution 80 (Big Twin). Fitment can vary by model year, so we confirm compatibility with your exact bike before ordering.
Does the S&S Cycle 640 need a tune?
Yes. On a carbureted engine, plan on re-jetting or a performance carb, and a programmable ignition helps match timing to the new cam.
Is the S&S Cycle 640 a good cam for me?
This is a top-end grind. It gives up some bottom-end grunt to make more power at higher rpm, and it rewards riders who like to rev the engine out. It works best with more displacement or compression, so it's usually paired with a big bore kit or a higher-compression build.
Estimates for a healthy engine. Real results depend on condition, the rest of the build, the tune and the dyno.
Install the S&S Cycle 640
Arch Customs installs and dyno tunes Harley cams at our shop in Stellarton, Nova Scotia, with tensioners, pushrods and every supporting part done right.
Build it in the calculatorRequest a quote