S&S Cycle · Top-end power
S&S Cycle 561 Cam: Horsepower & Torque Gains
Strong 3,000–5,500 rpm. Made for 88–96 ci with 9.5–10.5:1 compression; needs high-lift springs.
This is a top-end grind. It gives up some bottom-end grunt to make more power at higher rpm, and it rewards riders who like to rev the engine out.
Estimated Gains by Engine
Rear-wheel estimates for a Stage 1 engine (high-flow air cleaner, 2-into-1 exhaust and custom tune, or a performance carb) before and after the S&S Cycle 561, which makes it a Stage 2 build.
| Engine | Stock | Stage 1 | Stage 2 with 561 | Try it |
|---|---|---|---|---|
| Evolution 80 (Big Twin) | 57 hp / 68 ft-lb | 65 hp / 74 ft-lb | 73 hp / 77 ft-lb | Open in calculator → |
Supporting Mods for the S&S Cycle 561
- Consider: This grind makes its best power with more displacement or compression, so it's usually paired with a big bore kit.
- Recommended: Adjustable pushrods. They let us install the cam without pulling the rocker boxes, saving labour.
- Consider: The S&S Cycle 561 makes its best power with more displacement or compression. A milder grind may suit a 80 ci engine better.
- Consider: A programmable ignition so timing can be matched to the new cam.
S&S Cycle 561 vs Similar Cams
Other top-end power grinds on the Evolution 80 (Big Twin), same supporting parts.
Full Harley cam comparison chart →S&S Cycle 561 FAQ
How much horsepower does the S&S Cycle 561 add in a Stage 2 build?
On a Stage 1 Evolution 80 (Big Twin) (high-flow intake, 2-into-1 exhaust and a custom tune), we estimate the S&S Cycle 561 adds about 8 hp and 3 ft-lb at the rear wheel, for a Stage 2 build of roughly 73 hp / 77 ft-lb.
What engines does the S&S Cycle 561 fit?
The S&S Cycle 561 is listed for the Evolution 80 (Big Twin). Fitment can vary by model year, so we confirm compatibility with your exact bike before ordering.
Does the S&S Cycle 561 need a tune?
Yes. On a carbureted engine, plan on re-jetting or a performance carb, and a programmable ignition helps match timing to the new cam.
Is the S&S Cycle 561 a good cam for me?
This is a top-end grind. It gives up some bottom-end grunt to make more power at higher rpm, and it rewards riders who like to rev the engine out. It works best with more displacement or compression, so it's usually paired with a big bore kit or a higher-compression build.
Estimates for a healthy engine. Real results depend on condition, the rest of the build, the tune and the dyno.
Install the S&S Cycle 561
Arch Customs installs and dyno tunes Harley cams at our shop in Stellarton, Nova Scotia, with tensioners, pushrods and every supporting part done right.
Build it in the calculatorRequest a quote