Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P2105

Electronic throttle control forced engine shutdown

Don't ride until it's checked

What P2105 means

These codes cover the motorized throttle body on ride-by-wire bikes and the protective modes the ECM uses when it detects a throttle problem, such as limited performance, power management or forced idle.

Common causes

  • →A sticking or dirty throttle body
  • →A failed throttle motor or motor circuit
  • →Twist grip or throttle position sensor faults
  • →Low battery voltage during start-up

What to check first

  1. Read all stored codes, since these are usually set alongside another fault
  2. Check battery condition and connections
  3. Have the throttle body inspected and the closed position relearned

Is it safe to ride?

Limited-performance and forced-idle modes are safety measures. Don't ride until the cause is found.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service