Powertrain (P) · ECM
Harley Code P2102
Throttle motor circuit low
What P2102 means
These codes cover the motorized throttle body on ride-by-wire bikes and the protective modes the ECM uses when it detects a throttle problem, such as limited performance, power management or forced idle.
The fault type in P2102
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A sticking or dirty throttle body
- →A failed throttle motor or motor circuit
- →Twist grip or throttle position sensor faults
- →Low battery voltage during start-up
What to check first
- Read all stored codes, since these are usually set alongside another fault
- Check battery condition and connections
- Have the throttle body inspected and the closed position relearned
Is it safe to ride?
Limited-performance and forced-idle modes are safety measures. Don't ride until the cause is found.
Related electronic throttle control (etc) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.