Powertrain (P) · ECM
Harley Code P1512
Electronic throttle control forced idle mode
What P1512 means
These codes cover the motorized throttle body on ride-by-wire bikes and the protective modes the ECM uses when it detects a throttle problem, such as limited performance, power management or forced idle.
Common causes
- →A sticking or dirty throttle body
- →A failed throttle motor or motor circuit
- →Twist grip or throttle position sensor faults
- →Low battery voltage during start-up
What to check first
- Read all stored codes, since these are usually set alongside another fault
- Check battery condition and connections
- Have the throttle body inspected and the closed position relearned
Is it safe to ride?
Limited-performance and forced-idle modes are safety measures. Don't ride until the cause is found.
Related electronic throttle control (etc) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.