Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1270

Twist grip sensor 2 A/D validation error

Don't ride until it's checked

What P1270 means

On electronic throttle (ride-by-wire) bikes, the twist grip sensor reads your throttle hand position and sends it to the ECM. It has two sensors that must agree.

The fault type in P1270

Signal not plausible

The signal is inside its electrical limits but doesn't make sense compared to what the module expects, or doesn't agree with a second sensor. A sensor drifting out of calibration, a mechanical problem, or high resistance in a connector can cause this.

How it's tested: Compare the live sensor reading against the actual condition, such as throttle position, temperature or speed. Clean and check the connector, and check for a mechanical cause before replacing the sensor.

Common causes

  • →A worn or failed twist grip sensor
  • →Damaged handlebar wiring, often after bar or cable changes
  • →A loose connector

What to check first

  1. Inspect the handlebar wiring, especially after bar swaps
  2. Check the twist grip sensor connector
  3. Test the sensor outputs with a diagnostic tool

Is it safe to ride?

The bike may limit power or go to forced idle. Don't ride it until the throttle control is repaired.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service