Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1019

Engine coolant temperature difference (high temperature)

Don't ride until it's checked

What P1019 means

The engine temperature (ET) or coolant temperature (ECT) sensor tells the ECM how hot the engine is. It affects starting, fuelling, idle and overheating protection. A low or high code means the signal is out of range; overheating codes mean the engine actually got too hot.

Common causes

  • →A failed or loose temperature sensor
  • →Damaged wiring near the cylinders
  • →Genuine overheating: low coolant, a failed fan, or a lean condition
  • →Long idling or slow traffic in hot weather

What to check first

  1. Check the sensor connector and wiring
  2. On liquid-cooled engines, check coolant level and fan operation
  3. Look for a lean condition or exhaust leak if the engine really is running hot

Is it safe to ride?

If the code means real overheating, stop and let the engine cool. Riding an overheating engine can cause serious damage.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service