Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P2128

Twist grip sensor 2 (TGS2) high

Don't ride until it's checked

What P2128 means

On electronic throttle (ride-by-wire) bikes, the twist grip sensor reads your throttle hand position and sends it to the ECM. It has two sensors that must agree.

The fault type in P2128

Signal or voltage high

The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.

Common causes

  • →A worn or failed twist grip sensor
  • →Damaged handlebar wiring, often after bar or cable changes
  • →A loose connector

What to check first

  1. Inspect the handlebar wiring, especially after bar swaps
  2. Check the twist grip sensor connector
  3. Test the sensor outputs with a diagnostic tool

Is it safe to ride?

The bike may limit power or go to forced idle. Don't ride it until the throttle control is repaired.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service