Powertrain (P) · ECM
Harley Code P0117
Engine temperature (ET) sensor low
What P0117 means
The engine temperature (ET) or coolant temperature (ECT) sensor tells the ECM how hot the engine is. It affects starting, fuelling, idle and overheating protection. A low or high code means the signal is out of range; overheating codes mean the engine actually got too hot.
The fault type in P0117
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A failed or loose temperature sensor
- →Damaged wiring near the cylinders
- →Genuine overheating: low coolant, a failed fan, or a lean condition
- →Long idling or slow traffic in hot weather
What to check first
- Check the sensor connector and wiring
- On liquid-cooled engines, check coolant level and fan operation
- Look for a lean condition or exhaust leak if the engine really is running hot
Is it safe to ride?
If the code means real overheating, stop and let the engine cool. Riding an overheating engine can cause serious damage.
Related engine and coolant temperature sensors codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.