Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1004

System relay contacts closed

Don't ride until it's checked

What P1004 means

The system relay powers key engine components. These codes mean its coil or contacts aren't behaving correctly.

Common causes

  • →A failed system relay
  • →A corroded relay socket or fuse block
  • →Low battery voltage

What to check first

  1. Swap or test the system relay
  2. Inspect the fuse and relay block for corrosion

Is it safe to ride?

A relay fault can cause a no-start or sudden shutdown.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service