Powertrain (P) · ECM
Harley Code P1002
System relay coil high/shorted
What P1002 means
The system relay powers key engine components. These codes mean its coil or contacts aren't behaving correctly.
The fault type in P1002
Short to voltage
The circuit is seeing battery voltage where it shouldn't, so the module reads it as stuck high. This usually means the wire is touching a powered wire, often where two harnesses run together or after accessory wiring was added.
How it's tested: With the key on and the component unplugged, check the signal wire for voltage. If voltage is there with everything disconnected, trace the harness for a pinched or melted section, and check any accessory wiring that was spliced in.
Common causes
- →A failed system relay
- →A corroded relay socket or fuse block
- →Low battery voltage
What to check first
- Swap or test the system relay
- Inspect the fuse and relay block for corrosion
Is it safe to ride?
A relay fault can cause a no-start or sudden shutdown.
Related system relay codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.