Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P0123

Throttle position sensor 1 (TPS1) high/open

Don't ride until it's checked

What P0123 means

On ride-by-wire Harleys the throttle body has two position sensors that the ECM cross-checks. A range or correlation error means a sensor reading doesn't make sense or the two disagree.

The fault type in P0123

Open circuit

The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.

How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.

Signal or voltage high

The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.

Common causes

  • →A dirty or failing throttle body
  • →Connector corrosion or a loose pin
  • →Damaged wiring
  • →A failed throttle position sensor

What to check first

  1. Inspect the throttle body connector
  2. Check for contamination around the throttle plate
  3. Have the throttle body tested with a diagnostic tool

Is it safe to ride?

Throttle faults can put the bike into reduced power or forced idle. Don't ride it until it's diagnosed.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service