Powertrain (P) · ECM
Harley Code P0122
Throttle position sensor 1 (TPS1) low
What P0122 means
On ride-by-wire Harleys the throttle body has two position sensors that the ECM cross-checks. A range or correlation error means a sensor reading doesn't make sense or the two disagree.
The fault type in P0122
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A dirty or failing throttle body
- →Connector corrosion or a loose pin
- →Damaged wiring
- →A failed throttle position sensor
What to check first
- Inspect the throttle body connector
- Check for contamination around the throttle plate
- Have the throttle body tested with a diagnostic tool
Is it safe to ride?
Throttle faults can put the bike into reduced power or forced idle. Don't ride it until it's diagnosed.
Related throttle position sensors (tps) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.