Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P0120

Throttle position sensor 1 (TPS1) range error

Don't ride until it's checked

What P0120 means

On ride-by-wire Harleys the throttle body has two position sensors that the ECM cross-checks. A range or correlation error means a sensor reading doesn't make sense or the two disagree.

The fault type in P0120

Signal not plausible

The signal is inside its electrical limits but doesn't make sense compared to what the module expects, or doesn't agree with a second sensor. A sensor drifting out of calibration, a mechanical problem, or high resistance in a connector can cause this.

How it's tested: Compare the live sensor reading against the actual condition, such as throttle position, temperature or speed. Clean and check the connector, and check for a mechanical cause before replacing the sensor.

Common causes

  • →A dirty or failing throttle body
  • →Connector corrosion or a loose pin
  • →Damaged wiring
  • →A failed throttle position sensor

What to check first

  1. Inspect the throttle body connector
  2. Check for contamination around the throttle plate
  3. Have the throttle body tested with a diagnostic tool

Is it safe to ride?

Throttle faults can put the bike into reduced power or forced idle. Don't ride it until it's diagnosed.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service