Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · IM / speedometer

Harley Code B1200

Instrument module internal fault

Ride with caution

What B1200 means

The instrument module detected an internal fault.

The fault type in B1200

Internal module fault

The module's own self-test found a problem inside it. Low or unstable supply voltage can trigger a false internal fault, so the power supply needs ruling out before you condemn the module.

How it's tested: Clear the code and see if it returns. Load-test the battery and check the module's power and ground connections. Only replace or reprogram the module once supply voltage is confirmed good.

Common causes

  • →An internal instrument failure
  • →Water intrusion
  • →Low voltage

What to check first

  1. Check battery voltage
  2. Inspect the gauge connectors

Is it safe to ride?

Your speedometer and warning lights may not be reliable.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service