Body (B) · Various
Harley Code B1301
Radio voltage low
What B1301 means
A module saw supply voltage that was too low or too high. Low voltage usually points to the battery, connections or charging system. High voltage usually points to a failed voltage regulator.
The fault type in B1301
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A weak or failing battery
- →Loose or corroded battery terminals and grounds
- →A failed stator or voltage regulator
- →Jump-starting or charger problems
What to check first
- Load-test the battery
- Clean and tighten battery terminals and main grounds
- Test charging output at idle and 2,000+ rpm
Is it safe to ride?
Low or high voltage can strand you or damage electronics. Test the battery and charging system before a long ride.
Related battery and system voltage codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.