Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1354

Rear ignition coil driver open/low

Don't ride until it's checked

What P1354 means

The ECM found a problem in the front or rear ignition coil driver circuit: open, low or shorted.

The fault type in P1354

Open circuit

The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.

How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.

Signal or voltage low

The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.

Common causes

  • →A failed ignition coil
  • →A loose or corroded coil connector
  • →Damaged coil wiring

What to check first

  1. Check coil connectors and wiring
  2. Measure coil primary and secondary resistance
  3. Inspect spark plug wires and plugs

Is it safe to ride?

A coil fault means a cylinder may not fire. Riding can damage the engine or exhaust.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service