Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1352

Front ignition coil driver high/shorted

Don't ride until it's checked

What P1352 means

The ECM found a problem in the front or rear ignition coil driver circuit: open, low or shorted.

The fault type in P1352

Short to voltage

The circuit is seeing battery voltage where it shouldn't, so the module reads it as stuck high. This usually means the wire is touching a powered wire, often where two harnesses run together or after accessory wiring was added.

How it's tested: With the key on and the component unplugged, check the signal wire for voltage. If voltage is there with everything disconnected, trace the harness for a pinched or melted section, and check any accessory wiring that was spliced in.

Common causes

  • →A failed ignition coil
  • →A loose or corroded coil connector
  • →Damaged coil wiring

What to check first

  1. Check coil connectors and wiring
  2. Measure coil primary and secondary resistance
  3. Inspect spark plug wires and plugs

Is it safe to ride?

A coil fault means a cylinder may not fire. Riding can damage the engine or exhaust.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service