Powertrain (P) · ECM
Harley Code P0572
Brake switch low
What P0572 means
A brake, cruise control or clutch switch input reads an unexpected state, such as stuck on or shorted.
The fault type in P0572
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →A sticking or misadjusted brake light switch
- →Damaged handlebar wiring
- →A failed switch
What to check first
- Check that the brake light turns on and off correctly
- Inspect handlebar switch wiring
- Test the switch with a meter
Is it safe to ride?
Check your brake light works before riding, since other drivers rely on it. Cruise control may be disabled.
Related brake, clutch and cruise switch inputs codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.