Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · ECM

Harley Code B2262

Front brake switch stuck

Ride with caution

What B2262 means

A brake, cruise control or clutch switch input reads an unexpected state, such as stuck on or shorted.

The fault type in B2262

Switch stuck or implausible

The module saw a switch state that doesn't make sense, such as a switch that never changes or two contacts that disagree. Worn or misadjusted switches and corroded contacts are common causes.

How it's tested: Watch the switch input change state on a scan tool while you work the switch. Check adjustment and look for dirt or corrosion in the switch and its connector.

Common causes

  • →A sticking or misadjusted brake light switch
  • →Damaged handlebar wiring
  • →A failed switch

What to check first

  1. Check that the brake light turns on and off correctly
  2. Inspect handlebar switch wiring
  3. Test the switch with a meter

Is it safe to ride?

Check your brake light works before riding, since other drivers rely on it. Cruise control may be disabled.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service