Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P0052

Rear HO2S heater circuit shorted/high

Ride with caution

What P0052 means

The oxygen sensors in the head pipes tell the ECM how rich or lean the engine is running, so it can trim the fuel mixture. A lean or rich code means the reading stayed outside the range the ECM can correct, or the sensor or its heater circuit failed.

The fault type in P0052

Short to voltage

The circuit is seeing battery voltage where it shouldn't, so the module reads it as stuck high. This usually means the wire is touching a powered wire, often where two harnesses run together or after accessory wiring was added.

How it's tested: With the key on and the component unplugged, check the signal wire for voltage. If voltage is there with everything disconnected, trace the harness for a pinched or melted section, and check any accessory wiring that was spliced in.

Common causes

  • →An exhaust leak at the head pipe flange (common lean cause)
  • →A failed or contaminated O2 sensor
  • →Damaged or chafed sensor wiring or connector
  • →Aftermarket exhaust or intake without a matching tune
  • →Low fuel pressure or a dirty injector

What to check first

  1. Look for exhaust leaks and loose head pipe nuts
  2. Inspect the sensor connector and wiring near the exhaust
  3. Confirm the tune matches your exhaust and air cleaner
  4. Check fuel pressure if the code keeps returning

Is it safe to ride?

Usually rideable for short distances, but a lean engine runs hot. Get it checked soon, especially on a big-twin in summer.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service