Powertrain (P) · ECM
Harley Code P0051
Rear HO2S heater circuit low/open
What P0051 means
The oxygen sensors in the head pipes tell the ECM how rich or lean the engine is running, so it can trim the fuel mixture. A lean or rich code means the reading stayed outside the range the ECM can correct, or the sensor or its heater circuit failed.
The fault type in P0051
Open circuit
The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.
How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.
Signal or voltage low
The voltage the module reads is below the range it expects. On a sensor circuit this usually points to a short to ground or a failed sensor. On a supply voltage code it means system voltage really is low.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, load-test the battery and check the charging system. For sensors, check the 5-volt reference and the signal wire for a short to ground.
Common causes
- →An exhaust leak at the head pipe flange (common lean cause)
- →A failed or contaminated O2 sensor
- →Damaged or chafed sensor wiring or connector
- →Aftermarket exhaust or intake without a matching tune
- →Low fuel pressure or a dirty injector
What to check first
- Look for exhaust leaks and loose head pipe nuts
- Inspect the sensor connector and wiring near the exhaust
- Confirm the tune matches your exhaust and air cleaner
- Check fuel pressure if the code keeps returning
Is it safe to ride?
Usually rideable for short distances, but a lean engine runs hot. Get it checked soon, especially on a big-twin in summer.
Related oxygen (o2) sensors codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.