Body (B) · TSM / BCM
Harley Code B2250
Clutch switch stuck
What B2250 means
A clutch switch or neutral switch input is shorted or stuck. These switches control starting safety and the neutral light.
The fault type in B2250
Switch stuck or implausible
The module saw a switch state that doesn't make sense, such as a switch that never changes or two contacts that disagree. Worn or misadjusted switches and corroded contacts are common causes.
How it's tested: Watch the switch input change state on a scan tool while you work the switch. Check adjustment and look for dirt or corrosion in the switch and its connector.
Common causes
- →A misadjusted or failed clutch switch
- →A failed neutral switch
- →Damaged wiring
What to check first
- Check that the neutral light works
- Inspect clutch switch wiring at the lever
Is it safe to ride?
The bike may not start or the neutral light may be wrong. Confirm you're in neutral before starting.
Related clutch and neutral switches codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.