Body (B) · BCM
Harley Code B2233
Fork lock shorted low
What B2233 means
The fork lock sensor or configuration reported a problem.
The fault type in B2233
Short to ground
The circuit is touching ground somewhere it shouldn't, so the module sees little or no voltage. On a motorcycle this is usually a wire with worn-through insulation rubbing on the frame, or water in a connector.
How it's tested: Unplug the component and the module, then check the signal wire for continuity to ground. Any reading means the short is in the harness, not the part. Look closely where the harness bends at the steering head and passes along the frame.
Common causes
- →A failed fork lock sensor
- →Wiring damage
- →Incorrect BCM configuration
What to check first
- Make sure the fork lock is fully released
- Inspect the sensor wiring
Is it safe to ride?
Make sure the steering turns freely before riding.
Related fork lock codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.