Body (B) · TSM / BCM
Harley Code B2212
Run/stop switch inputs both closed
What B2212 means
The ignition switch or run/stop switch input is open, shorted or giving conflicting signals.
The fault type in B2212
Switch stuck or implausible
The module saw a switch state that doesn't make sense, such as a switch that never changes or two contacts that disagree. Worn or misadjusted switches and corroded contacts are common causes.
How it's tested: Watch the switch input change state on a scan tool while you work the switch. Check adjustment and look for dirt or corrosion in the switch and its connector.
Common causes
- →A worn or corroded switch
- →Damaged handlebar or ignition wiring
- →Water in the switch housing
What to check first
- Inspect the switch and connectors
- Check handlebar wiring
- Dry and clean the switch housing
Is it safe to ride?
Switch faults can cause the bike to shut off unexpectedly. Get it repaired first.
Related ignition and run/stop switch codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.