Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · TSM / BCM

Harley Code B2210

Run/stop switch inputs both open

Don't ride until it's checked

What B2210 means

The ignition switch or run/stop switch input is open, shorted or giving conflicting signals.

The fault type in B2210

Switch stuck or implausible

The module saw a switch state that doesn't make sense, such as a switch that never changes or two contacts that disagree. Worn or misadjusted switches and corroded contacts are common causes.

How it's tested: Watch the switch input change state on a scan tool while you work the switch. Check adjustment and look for dirt or corrosion in the switch and its connector.

Open circuit

The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.

How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.

Common causes

  • →A worn or corroded switch
  • →Damaged handlebar or ignition wiring
  • →Water in the switch housing

What to check first

  1. Inspect the switch and connectors
  2. Check handlebar wiring
  3. Dry and clean the switch housing

Is it safe to ride?

Switch faults can cause the bike to shut off unexpectedly. Get it repaired first.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service