Body (B) · BCM
Harley Code B2161
Brake lamp output open
What B2161 means
A body control module output (lighting, fuel pump, starter, accessory power or security antenna) is open, shorted or overloaded.
The fault type in B2161
Open circuit
The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.
How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.
Common causes
- →A failed bulb or LED
- →Aftermarket accessories overloading a circuit
- →A shorted or pinched wire
What to check first
- Check the affected light or accessory
- Remove recently added accessories and re-test
- Inspect wiring for shorts
Is it safe to ride?
Depending on the output, lights or the fuel pump may not work. Check them before riding.
Related body control module outputs codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.