Body (B) · BCM
Harley Code B2104
System power output overloaded
What B2104 means
A body control module output (lighting, fuel pump, starter, accessory power or security antenna) is open, shorted or overloaded.
The fault type in B2104
Overloaded output
The module is driving the output but more current is flowing than it allows, so it shuts that output down to protect itself. A shorted bulb or LED, the wrong replacement lamp, or a chafed wire are the usual causes.
How it's tested: Disconnect the load and see if the code stops resetting. Check that replacement lamps or LED signals are the correct type for the model, and inspect the wiring to the lamp for damage.
Common causes
- →A failed bulb or LED
- →Aftermarket accessories overloading a circuit
- →A shorted or pinched wire
What to check first
- Check the affected light or accessory
- Remove recently added accessories and re-test
- Inspect wiring for shorts
Is it safe to ride?
Depending on the output, lights or the fuel pump may not work. Check them before riding.
Related body control module outputs codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.