Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · TSM / HFSM / BCM

Harley Code B2151

Left rear turn signal output open

Ride with caution

What B2151 means

A turn signal output is open, shorted or overloaded. It often follows aftermarket LED signals or lighting changes.

The fault type in B2151

Open circuit

The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.

How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.

Common causes

  • →A burned-out bulb or failed LED
  • →LED signals without the correct load equalizer or module setting
  • →Damaged wiring or a pinched harness

What to check first

  1. Check every turn signal
  2. Confirm LED signals have the right equalizer or programming
  3. Inspect wiring at the signal stalks

Is it safe to ride?

Make sure your signals work before riding. Use hand signals if needed.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service