Mon–Fri 9am–5pm · (902) 755-6532

Body (B) · TSM / HFSM / BCM

Harley Code B1126

Right turn signal output short to battery

Ride with caution

What B1126 means

A turn signal output is open, shorted or overloaded. It often follows aftermarket LED signals or lighting changes.

The fault type in B1126

Short to voltage

The circuit is seeing battery voltage where it shouldn't, so the module reads it as stuck high. This usually means the wire is touching a powered wire, often where two harnesses run together or after accessory wiring was added.

How it's tested: With the key on and the component unplugged, check the signal wire for voltage. If voltage is there with everything disconnected, trace the harness for a pinched or melted section, and check any accessory wiring that was spliced in.

Common causes

  • →A burned-out bulb or failed LED
  • →LED signals without the correct load equalizer or module setting
  • →Damaged wiring or a pinched harness

What to check first

  1. Check every turn signal
  2. Confirm LED signals have the right equalizer or programming
  3. Inspect wiring at the signal stalks

Is it safe to ride?

Make sure your signals work before riding. Use hand signals if needed.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service