Mon–Fri 9am–5pm · (902) 755-6532

Network (U) · Network

Harley Code U1302

Accessory bus performance error

Ride with caution

What U1302 means

Modules on the bike talk to each other over a data network (CAN bus or serial data). These codes mean that network is faulty or the signal is out of range.

Common causes

  • →A damaged data bus wire
  • →A failed module pulling the network down
  • →Aftermarket accessories spliced into the data lines
  • →Water in a connector

What to check first

  1. Inspect data bus connectors and wiring
  2. Unplug modules one at a time to isolate the fault
  3. Check for aftermarket wiring tapped into the bus

Is it safe to ride?

Gauges, ABS or security may misbehave. Have it diagnosed before a long trip.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service