Network (U) · Network
Harley Code U1300
Serial data low
What U1300 means
Modules on the bike talk to each other over a data network (CAN bus or serial data). These codes mean that network is faulty or the signal is out of range.
Common causes
- →A damaged data bus wire
- →A failed module pulling the network down
- →Aftermarket accessories spliced into the data lines
- →Water in a connector
What to check first
- Inspect data bus connectors and wiring
- Unplug modules one at a time to isolate the fault
- Check for aftermarket wiring tapped into the bus
Is it safe to ride?
Gauges, ABS or security may misbehave. Have it diagnosed before a long trip.
Related can bus and serial data codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.