Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P1356

Rear cylinder no combustion

Don't ride until it's checked

What P1356 means

The ECM detected no combustion, or intermittent combustion, in the front or rear cylinder.

Common causes

  • →Fouled or worn spark plugs
  • →A failing coil or plug wire
  • →A fuel injector problem
  • →Low compression from a mechanical issue

What to check first

  1. Inspect spark plugs and plug wires
  2. Check coil and injector circuits
  3. Do a compression or leak-down test if the misfire persists

Is it safe to ride?

Misfires can overheat the exhaust and damage the engine. Get it checked before riding further.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service