Powertrain (P) · ECM
Harley Code P0692
Fan/cooling relay output high
What P0692 means
A cooling fan or fan relay circuit is open or shorted. These apply to liquid-cooled and Twin-Cooled engines and some models with cooling fans.
The fault type in P0692
Signal or voltage high
The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.
How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.
Common causes
- →A failed fan motor
- →A failed relay
- →Damaged fan wiring or connector
What to check first
- Check whether the fan runs when the engine is hot
- Test the relay and fuse
- Inspect the fan connector
Is it safe to ride?
Without the fan the engine can overheat in slow traffic. Watch the temperature and avoid idling.
Related cooling fans and fan relay codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.