Powertrain (P) · ECM
Harley Code P0371
Crankshaft position (CKP) sensor wrong number of pulses
What P0371 means
The CKP sensor tells the ECM where the crankshaft is so it can time the spark and fuel. Wrong pulse counts, intermittent signals or sync errors mean that signal is unreliable.
The fault type in P0371
Signal not plausible
The signal is inside its electrical limits but doesn't make sense compared to what the module expects, or doesn't agree with a second sensor. A sensor drifting out of calibration, a mechanical problem, or high resistance in a connector can cause this.
How it's tested: Compare the live sensor reading against the actual condition, such as throttle position, temperature or speed. Clean and check the connector, and check for a mechanical cause before replacing the sensor.
Common causes
- →A failed or dirty CKP sensor
- →A loose or corroded connector
- →Damaged wiring near the crankcase
- →Metal debris on the sensor tip
What to check first
- Inspect the sensor and connector
- Clean the sensor tip and check for debris
- Check the wiring for chafing
Is it safe to ride?
CKP faults can cause stalling or a no-start without warning. Don't rely on the bike until it's fixed.
Related crankshaft position (ckp) sensor codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.