Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P0108

MAP sensor failed high

Ride with caution

What P0108 means

The MAP sensor reads intake manifold pressure, which the ECM uses to calculate engine load and fuelling. A low or high code means the signal voltage is out of range.

The fault type in P0108

Signal or voltage high

The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.

Common causes

  • →A loose or damaged MAP sensor connector
  • →A cracked or leaking intake seal or vacuum port
  • →A failed MAP sensor
  • →Wiring chafed against the frame or throttle body

What to check first

  1. Check the sensor seal and the intake manifold for leaks
  2. Inspect the connector for corrosion or a loose lock
  3. Measure the 5-volt reference and signal at the sensor

Is it safe to ride?

The ECM falls back to default values, so the bike may run poorly. Ride only as far as needed to get it checked.

Related manifold absolute pressure (map) sensor codes

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service