Mon–Fri 9am–5pm · (902) 755-6532

Powertrain (P) · ECM

Harley Code P0073

Ambient air temperature (AAT) sensor high/open

Usually safe to ride

What P0073 means

The ambient air temperature sensor reports outside air temperature to the ECM and gauges. The code means the circuit voltage is out of range.

The fault type in P0073

Open circuit

The circuit is broken, so current can't flow through it. A connector that has backed out, a broken wire, or a failed coil or sensor element are the usual causes. On some sensor circuits an open also reads as a high voltage, which is why open and high are often listed together.

How it's tested: Unplug the component and measure its resistance against the service manual specification. If the part is good, check the wiring back to the module for continuity end to end.

Signal or voltage high

The voltage the module reads is above the range it expects. On a sensor circuit this usually means an open ground or signal wire, or a short to voltage. On a supply voltage code it often means the voltage regulator is overcharging.

How it's tested: Measure the voltage at the component with the key on. For supply voltage codes, check charging voltage at the battery with the engine running. For sensors, check the ground wire and look for a short to voltage.

Common causes

  • →A damaged or unplugged sensor
  • →Open or shorted wiring

What to check first

  1. Inspect the sensor and its connector
  2. Check the wiring for damage

Is it safe to ride?

Usually rideable. It mainly affects temperature readings and some fuelling corrections.

Related ambient air temperature (aat) sensor codes

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service