Mon–Fri 9am–5pm · (902) 755-6532

Chassis (C) · ABS

Harley Code C1089

Pressure sensor external supply error

Ride with caution

What C1089 means

On linked-brake and Reflex Defensive Rider Systems (RDRS) bikes, pressure sensors in the ABS unit measure brake pressure. These codes mean a reading or supply is out of range.

Common causes

  • →A sensor or hydraulic unit fault
  • →Air in the brake system
  • →Wiring or connector problems

What to check first

  1. Check brake fluid level and bleed condition
  2. Inspect the ABS module connector
  3. Run ABS diagnostics

Is it safe to ride?

Linked braking and ABS may be disabled. Test the brakes carefully and get them checked.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service