Chassis (C) · ABS
Harley Code C1029
ABS wheel speed difference too high
What C1029 means
The ABS module reads front and rear wheel speed to detect lock-up. These codes mean a wheel speed signal is missing, intermittent, or doesn't match the other wheel.
Common causes
- →A dirty, damaged or loose wheel speed sensor
- →A damaged sensor ring (encoder)
- →Wrong tire size or a recent wheel change
- →Damaged sensor wiring
What to check first
- Clean and inspect the sensor and encoder ring
- Check sensor wiring near the axle
- Confirm correct tire sizes front and rear
Is it safe to ride?
ABS is usually disabled with the warning light on. Normal braking still works, but ride carefully and get it repaired.
Related abs wheel speed sensors codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.