Body (B) · Radio / LHCM / RHCM
Harley Code B1327
RHCM CB push-to-talk button stuck
What B1327 means
A radio, faceplate or hand-control button is reported as stuck, or a hand-control module has an internal fault.
The fault type in B1327
Switch stuck or implausible
The module saw a switch state that doesn't make sense, such as a switch that never changes or two contacts that disagree. Worn or misadjusted switches and corroded contacts are common causes.
How it's tested: Watch the switch input change state on a scan tool while you work the switch. Check adjustment and look for dirt or corrosion in the switch and its connector.
Common causes
- →A sticking button from dirt or moisture
- →A damaged hand-control harness
- →A failed control module
What to check first
- Press and release the button to see if it frees up
- Inspect hand control wiring
- Clean the switch housing
Is it safe to ride?
Usually rideable, as long as the stuck switch isn't a safety control such as the horn or signals.
Related infotainment and hand controls codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.