Body (B) · TSM / BCM
Harley Code B1151
Bank angle sensor (BAS) short to ground
What B1151 means
The bank angle sensor shuts the engine off if the bike tips over. These codes mean its circuit is open, shorted or out of range.
The fault type in B1151
Short to ground
The circuit is touching ground somewhere it shouldn't, so the module sees little or no voltage. On a motorcycle this is usually a wire with worn-through insulation rubbing on the frame, or water in a connector.
How it's tested: Unplug the component and the module, then check the signal wire for continuity to ground. Any reading means the short is in the harness, not the part. Look closely where the harness bends at the steering head and passes along the frame.
Common causes
- →A failed bank angle sensor
- →Damaged wiring or connector
- →The bike was dropped or laid over
What to check first
- Check the sensor connector and mounting
- Inspect wiring for damage
Is it safe to ride?
A faulty bank angle sensor can stop the engine while riding.
Related bank angle sensor (bas) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.