Body (B) · TSM / TSSM / HFSM
Harley Code B1144
Security antenna short to battery
What B1144 means
The turn signal and security module reported a problem with its alarm, accelerometer (tip-over sensor), antenna or starter output.
The fault type in B1144
Short to voltage
The circuit is seeing battery voltage where it shouldn't, so the module reads it as stuck high. This usually means the wire is touching a powered wire, often where two harnesses run together or after accessory wiring was added.
How it's tested: With the key on and the component unplugged, check the signal wire for voltage. If voltage is there with everything disconnected, trace the harness for a pinched or melted section, and check any accessory wiring that was spliced in.
Common causes
- →A failed security module
- →Antenna or wiring damage
- →Aftermarket alarm or lighting wiring
What to check first
- Inspect the module connector and antenna wiring
- Check for aftermarket accessories spliced into the harness
Is it safe to ride?
Security or starting problems may follow. Have it diagnosed.
Related security module (tsm / tssm / hfsm) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.