Body (B) · TSM / TSSM / HFSM
Harley Code B1142
Smart security system internal fault
What B1142 means
The turn signal and security module reported a problem with its alarm, accelerometer (tip-over sensor), antenna or starter output.
The fault type in B1142
Internal module fault
The module's own self-test found a problem inside it. Low or unstable supply voltage can trigger a false internal fault, so the power supply needs ruling out before you condemn the module.
How it's tested: Clear the code and see if it returns. Load-test the battery and check the module's power and ground connections. Only replace or reprogram the module once supply voltage is confirmed good.
Common causes
- →A failed security module
- →Antenna or wiring damage
- →Aftermarket alarm or lighting wiring
What to check first
- Inspect the module connector and antenna wiring
- Check for aftermarket accessories spliced into the harness
Is it safe to ride?
Security or starting problems may follow. Have it diagnosed.
Related security module (tsm / tssm / hfsm) codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.